tube bundle

英 [tjuːb ˈbʌndl] 美 [tuːb ˈbʌndl]

网络  管束

化学



双语例句

  1. Tube bundle of tube-type heat exchanger Experimental investigation of heat recovery with thermosyphon heat exchanger
    列管式换热器的管束热管式通风换热器热回收的实验研究
  2. Use items including tube clip to fix the tube bundle wrapped to the wall.
    将包好的管束用管夹等物品固定在墙上。
  3. Experimental Research on the Deposition Characteristic of Silicon Powder on the Surface of Convection Tube Bundle
    硅灰在对流管束表面沉积特性的试验研究
  4. Image converter and intensifiers tube bundle of tube-type heat exchanger
    图像换管和图像增强管列管式换热器的管束
  5. Corrosion analysis of the tube bundle of hydrodenitrogenation product air cooler
    加氢脱氮反应产物空冷器管束腐蚀分析
  6. The flow and heat-transfer characteristics of a new type of heat-transfer enhancement element, namely, the twisted tape as the tube bundle support, are analyzed.
    分析了一种新型的传热强化元件&旋流片作为管间支撑物时的流动与传热特性。
  7. Causes Analysis of Tube Bundle Deformation of Economizer for 130 t/ h Gas-fired Boiler
    130t/h燃气锅炉省煤器管束变形原因分析及治理
  8. The experimental correlations for the forced convection-condensation heat transfer of flue gas in the heat exchanger are obtained by the experimental study result. Experimental Investigation of Flow Heat Transfer Correlation Through Tube Bundle Channel
    根据实验研究结果拟合出了肋片管式冷凝换热器烟气强迫对流凝结换热的实验关联式。管束间狭窄通道单相及沸腾流动传热实验关联式
  9. The tube bundle shall be designed, constructed, tested and stamped in accordance with the requirement following relevant codes and standards.
    管束应按相关规范和标准的要求设计、构造、测试和压印。
  10. The arrangement and layout make a public impact on the steam resistance extent of condenser, uniform steam distribution in the tube bundle and the occurrence of dead zone full of air, etc.
    管束的排列和布置型式对凝汽器的汽阻大小、蒸汽在管束中的分配是否均匀,以及是否会出现空气积聚的死区等都有影响。
  11. Performance Simulation and Optimization Analysis of Falling-Film Evaporator with Horizontal Tube Bundle Analysis of Corrosion Failure of Tube in Surface Evaporative Air Cooler and Protection
    水平管式降膜蒸发器性能仿真及优化分析表面蒸发式空气冷却器管束腐蚀及防护
  12. Replacing Technology for Heat Exchanger Tube Bundle of ⅰ-effect Evaporator in Aluminum Plant
    氧化铝厂Ⅰ效蒸发器热交换器管束更换工艺
  13. Mechanical vibration and built-in heating tube bundle are introduced, and the experiment is done for spraying granulation characteristics at different operating conditions by using the1.
    为了开发内热式振动流化床造粒技术的潜在应用价值,对流化床喷雾造粒装置进行改进,同时引入了机械振动和内置加热管群,并以1。
  14. Prediction of the Performance of Falling Film Evaporator with Horizontal Tube Bundle Based on a Distributed Parameter Model
    基于分布参数模型的水平管式降膜蒸发器模拟
  15. Tube bundle of tube-type heat exchanger
    多程及折流式换热器列管式换热器的管束
  16. Numerical investigation of heat transfer in tube bundle cross-flow for elliptic and egg-shaped tubes
    横掠蛋形和椭圆管束对流换热的数值模拟研究
  17. Tube bundle processing elements analysis of shell and tube heat exchanger
    管壳式换热器管束加工工艺要点分析
  18. The reasonable layout of tube bundle can strengthen the heat regenerative effect and reduce flow steam resistance.
    合理的管束布置,对于强化回热作用,降低流动汽阻具有重要意义。
  19. Tube bundle of tube-type heat exchanger graphite resistance immersion heater
    列管式换热器的管束浸入式石墨电阻加热器
  20. Tube bundle of tube-type heat exchanger Those catalysts are used in small tubular reactors.
    列管式换热器的管束那些催化剂用于小型管式反应器。
  21. Based on measured data of Xingtai power plant, the paper improves traditional valuation method of condenser tube bundle arrangement correction factor.
    通过对邢台电厂实测数据的分析,对传统的评价凝汽器管束布置修正系数的方法进行了改进;
  22. Besides supporting the tube bundle, the twisted-leaves of 270-20.3 and 180-20.3 enhanced heat transfer obviously.
    除了起到支撑管束作用外,270-20.3和180-20.3旋流片还具有良好的强化传热效果。
  23. On the basis of analysing the structure and the heat transfer property for spiral finned tube bundle, the problems existing in design and operation of the spiral finned tube economizer have been pointed out based on the practical operation situation of the said economizer.
    在分析螺旋鳍片管束的结构与传热特点的基础上,根据螺旋鳍片管省煤器的实际运行状况,指出了螺旋鳍片管省煤器在设计与运行中存在的问题。
  24. The mechanism calculation model and experimental calculation model for boiling heat transfer outside horizontal tube bundle are summarized, and the enhancement methods of the boiling heat transfer are discussed.
    综述了水平管束外沸腾换热的机理性计算模型和实验性计算模型,探讨了水平管束外沸腾换热的强化方法。
  25. The experimental results are collected and compared on single experimental pipe, cross tube bundle, rectangle and triangle cross fin-tube.
    对单根试验管、叉排管束、矩形截面超片管和三角形截面翅片管的试验结果进行了综合比较。
  26. The seismic response analysis and experimental study of a model PWR steam generator tube bundle has been completed.
    完成了压水堆蒸汽发生器管束模拟体的地震响应水分析和试验研究。
  27. Seismic analysis and test of model steam generator tube bundle
    蒸汽发生器模拟管束的地震响应分析和试验
  28. Additionally, modal tests have been carried out for horizontal tube bundle and U-tube bundle.
    对U型管管束和卧式直管管束做了模态试验。
  29. Taking the integral low rib tube and the integral internal and outer rib tube of cup per-nickel alloy as the elements and the oil-water, water-water as the medium, a tube bundle tests of modeling heat exchangers have been done.
    以铜-镍合金整体低肋管和整体内外翅片管为元件,以油-水和水-水为介质对管束换热器模拟体进行了试验研究。
  30. A Study of Tube Bundle Fabricating Process for 121& C Inlet/ outlet Heat Exchanger of Ammonia Synthetic Tower
    121&C氨合成塔进出口换热器管系制造工艺研究和应用